Configuration
3.2 Load and Save
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
105
Call up the command with the following parameters:
save filetype <filetype> tftp {ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6
<ip6_addr>} [port <tcpport (1-65535)>] file <filename>
The parameters have the following meaning:
Keyword for a file type to be loaded
Name of the file type Maximum of 100 characters
Keyword for a TFTP server
Keyword for an IPv4 address
IPv4 unicast address of the TFTP
Enter a valid unicast IPv4 ad-
Keyword for a domain name
Domain name (Fully Qualified Domain
Maximum of 100 characters
Keyword for an IPv6 address
IPv6 address of the TFTP server Enter a valid unicast IPv6 ad-
Keyword for the port of the server via
which the TFTP connection runs
-
Keyword for a file name to be assigned
Maximum of 100 characters
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
For information on the file types , refer to this list (Page 101).
The file is saved on the TFTP server.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General