Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
621
You disable the function with the no ipv6 rip default-information originate command.
You display the IPv6 routing table with the
show ipv6 route command.
no ipv6 rip default-information
Description
With this command you disable the function that a standard route is generated in the IPv6
routing table for routes from the local RIP database.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameter assignment:
no ipv6 rip default-information
The function is disabled.
You enable IPv6 with the ipv6 enable command.
You enable the function with the
ipv6 rip default-information originate command.
This command enables RIPng routing on the interface.
To Next Page
Loading...
Need help?
General