Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
768 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
add log <log entry>
The parameter has the following meaning:
The entry has been made in the logbook.
client config
Description
With this command, you enable one of the clients that processes or forwards the messages
of the device.
The following clients are available:
●
syslog: sends the messages to the Syslog server
●
trap: sends the messages as SNMP trap to a configured recipient
●
email: sends the messages as e-mail
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
client config {syslog|trap|email|all}
The parameters have the following meaning:
Enables the client that sends the messages to the Syslog server
Enables the client that sends the SNMP traps
Enables the client that sends the e-mails
Enables all clients at once
To Next Page
Loading...
Need help?
General