Network protocols
7.5 DHCPv4 Relay Agent (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
328 Configuration Manual, 11/2015, C79000-G8976-C252-10
The DHCP Relay Agent is activated.
You disable the DHCP Relay Agent with the no service dhcp-relay command.
You create the IP addresses of the DHCP server with the
ip dhcp server command.
You can display the status of this function and other information with the
show ip dhcp relay
information
command.
no service dhcp-relay
Description
This command disables the DHCP relay agent.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no service dhcp-relay
The DHCP Relay Agent is disabled.
You enable the DHCP Relay Agent with the service dhcp-relay command.
You can display the status of this function and other information with the
show ip dhcp relay
information
command.
To Next Page
Loading...
Need help?
General