Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
336 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
ipv6 dhcp relay [destination <prefix> [interface {vlan <vlan-id (1-4094)> |
<interface-type> <interface-id>}]]
The parameters have the following meaning:
Keyword for the IPv6 address of the
destination DHCPv6 server
-
IPv6 address Enter a valid IPv6 address.
Shows that an interface description
-
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The DHCP Relay Agent is enabled.
You disable the DHCPv6 relay agent with the no ipv6 dhcp relay command.
You configure the interface as a router port with the
no switchport command.
You display the setting with the
show ipv6 dhcp interface command.
You display the statistics with the
show ipv6 dhcp relay statistics command.
no ipv6 dhcp relay
Description
With this command, you disable the DHCPv6 relay agent. You can also remove the DHCPv6
servers.
To Next Page
Loading...
Need help?
General