Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
203
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Call the command without parameters:
no name
The name of the VLAN is deleted.
You assign the VLAN a name with the command name.
transparent-vlan
Description
With this command, you change a VLAN to the transparent mode.
Ports that were assigned to this VLAN as members or untagged members now become
transparent ports.
This means the following:
● The port VLAN ID of the transparent ports is set to the ID of this VLAN.
● Untagged frames that are received at these ports are forwarded to all other transparent
ports once again without tag as long as they are not forwarded to a standard VLAN by a
protocol or subnet rule.
● Frames tagged with VLAN ID "0" and that are received at these ports are forwarded to all
other transparent ports once again tagged with VLAN ID "0" as long as they are not
forwarded to a standard VLAN by a protocol or subnet rule.
● Frames tagged with the VLAN ID of the transparent VLAN and that are received at these
ports are forwarded to all transparent ports once again tagged with the VLAN ID of the
transparent VLAN.
● Other frames are forwarded according to the normal VLAN rules and a transparent port
behaves like an untagged member in this VLAN.
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
To Next Page
Loading...
Need help?
General