Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
620 Configuration Manual, 11/2015, C79000-G8976-C252-10
9.7.4
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
Note
These commands are available only with layer 3.
9.7.4.1
ipv6 rip default-information originate
Description
With this command you enable the function that an IPv6 standard route is generated in the
IPv6 routing table via this interface for routes from the local RIP database.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 rip default-information originate
Result
The function is enabled.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English