Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
333
The configuration settings are displayed.
You enable the DHCPv6 relay agent function with the ipv6 dhcp relay. command.
clear ipv6 dhcp relay statistics
Description
With this command, you reset the counters.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call up the command with the following parameters:
clear ipv6 dhcp relay statistics [interface {vlan <VlanId(1-4094)> |<interface-type>
<interface-id>}]
The parameters have the following meaning:
Shows that an interface description follows
Keyword for a VLAN connection -
Number of the addressed VLAN
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not specify any parameters, the counter is reset on all interfaces.
The counters are reset.
To Next Page
Loading...
Need help?
General