Network protocols
7.1 IPv4 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
263
Call up the command with the following parameters:
show dcp forwarding [port<interface-type><interface-id>]
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The overview of the DCP forwarding behavior is displayed.
This command shows information about the DNS client, for example the status of the DNS
client and parameters for querying the DNS server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip dns
Information on the DNS client is displayed.
To Next Page
Loading...
Need help?
General