Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
634 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
match metric <value(0-0xffffff)>
The parameter has the following meaning:
Value of the metric 0 ... 0xffffff
You can enter the value in decimal or hexadecimal.
The filter for the value of the metric is created.
You delete the filter for the value of the metric with the no match metric command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
no match metric
Description
With this command, you delete the filter for the value of the metric.
Note
This command is availabl
e only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
To Next Page
Loading...
Need help?
General