Security and authentication
11.3 MAC access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
704 Configuration Manual, 11/2015, C79000-G8976-C252-10
MAC address of the permitted incom-
Enter a valid MAC address
Keyword for "all" -
Keyword for the MAC address of an
outgoing connection that is permitted
-
MAC address of the permitted outgoing
Enter a valid MAC address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Note
MAC address input
Use "any", if the rule is to apply to all src and/or dest MAC addresses. This corresponds to
the MAC address "00:00:00:00:00:00".
The MAC access control list is configured.
You exit the MAC ACL configuration mode with the exit command.
You delete the MAC access control list with the
no mac access-list extended command.
You display the configuration of the access control list with the
show access-lists command.
With this command, you configure a MAC address control list that describes the MAC
addresses for which incoming and/or outgoing data traffic is locked.
The access control list contains only one entry. If you want to lock or permit further
addresses, create a new access control list.
Note
Processing order of the lists
The access control lists are processed on the interface in the order in which they were
created.
The index number of the acc
ess control list is not used for this.
To Next Page
Loading...
Need help?
General