Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
569
This section describes the commands relevant for working with routing with VRRPv3.
Version 3 of VRRP is based on version 2.
Enable routing to be able to use VRRPv3.
The commands are only available with layer 3 and only in conjunction with VLAN
interfaces. Router ports are not supported.
Simultaneous operation of VRRP and VRRPv3 is not possible.
VRRPv3 supports IPv4 and IPv6. Both can be configured and operated at the same time
with VRRP3.
clear vrrp3 statistics
Description
With this command, you reset the counters to zero.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call the command without parameter assignment:
clear vrrp3 statistics
The counters are reset.
You display the table with the commands show vrrp3 interface and show vrrp3 interface -
vrid
.
This section describes commands with which you display various settings.
To Next Page
Loading...
Need help?
General