Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
619
9.7.3.8
no redistribute
Description
This command specifies which route information is not forwarded by RIP.
Note
This command is available only with layer 3.
Requirement
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
no redistribute {default | connected | ospf | static} [route-map <name(20)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
default
Default routes are not forwarded.
-
connected
Route information of local subnets is
not forwarded.
-
ospf
No routes learned by OSPF are for-
warded.
-
static
No static routes are forwarded.
-
route-map
Keyword for a route map.
-
name
Name of the route map.
Maximum of 20 characters
Result
In certain cases, forwarding of routing information is disabled.
Further notes
You enable the forwarding with the no redistribute metric command.
You display the setting and other information with the
show ipv6 rip command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English