Network protocols
7.1 IPv4 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
262 Configuration Manual, 11/2015, C79000-G8976-C252-10
show dcp server
Description
This command shows whether or not the DCP function is enabled on the device.
If the DCP function is enabled, the read and write permissions are displayed.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show dcp server
The overview of the status of the DCP function and access rights is displayed.
show dcp forwarding
Description
This command shows an overview of the DCP forwarding behavior on one or all interfaces.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General