Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
453
9.2.3.2
no ASBR Router
Description
With this command, you disable the autonomous system boundary router.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call the command without parameters:
no ASBR Router
Result
The autonomous system boundary router is disabled.
Further notes
You enable the autonomous system boundary router with the ASBR Router command.
You can display the status of this function and other information with the
show ip ospf
command.
9.2.3.3
area range
Description
With this command, you assign an area ID an address range. The address range is used to
group the routes within OSPF.
Note
This command is available only with layer 3.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English