Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
175
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show vlan device info
The global information is displayed.
show vlan learning params
Description
This command shows the parameters for the automatic learning of addresses for selected or
all VLANs (active and inactive VLANs).
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show vlan learning params[vlan<vlan-range>]
The parameters have the following meaning:
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or
VLAN range
1 ... 4094
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
The settings for the automatic learning of addresses are displayed.
To Next Page
Loading...
Need help?
General