Layer 2 management protocols
8.6 Multicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
425
Call up the command with the following parameters:
mac-address-table block static multicast <aa:aa:aa:aa:aa:aa> vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the VLAN 1 ... 4094
Keyword for a MAC address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameters from the parameter list, the default value is used.
The settings for static multicast blocking are configured.
You enable / disable the setting with the no mac-address-table static multicast <mac
address> <vlan-id(1-4094)>
command.
mac-address-table static multicast
Description
With this command, you configure a static multicast address.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General