Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
301
Call up the command with the following parameters:
no ipv6 address <prefix> link-local
The parameter has the following meaning:
Link local address Specify a valid link local address.
fe80::xxxx:xxxx:xxxx:xxxx
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The link local address is deleted.
You assign a link local address to an interface with the ipv6 address link-local command.
You display this setting and other information with the
show ipv6 interface command.
With this command, you enable IPv6 on the interface. As default, IPv6 is disabled.
● IPv6 routing is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
To Next Page
Loading...
Need help?
General