Siemens SCALANCE XR-500 Configuration Manual

Layer 2 management protocols
8.3 IGMP querier
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
401
Syntax
Call up the command with the following parameters:
no ip igmp snooping static-group <mcast_addr>
The parameter has the following meaning:
Parameter
Description
Range of values / note
static-group
Keyword for a static entry
-
mcast_addr
Value for a multicast address Enter a valid multicast address.
Result
The static IGMP entry has been deleted.
Further notes
You create a static IGMP entry with the ip igmp snooping static-group command.
8.3
IGMP querier
This section describes the commands for the query functionality of the Internet Group
Management Protocol (IGMP).
8.3.1
Commands in the Global Configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
8.3.1.1
ip igmp snooping querier
Description
With this command, you configure the IGMP snooping switch as querier.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English