Security and authentication
11.4 IP access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
716 Configuration Manual, 11/2015, C79000-G8976-C252-10
You delete an IP access control list with the no ip access-list standard <acl-num>
command.
You display the configuration of the access control list with the
show access-lists command.
With this command, you configure an IP access control list. The IP ACL contains a
description of the IP addresses for which the incoming and outgoing frames will not be
forwarded.
You have the following options:
● All incoming and/or outgoing frames are not forwarded.
● Incoming and/or outgoing frames of a specific host are not forwarded.
● Incoming and/or outgoing frames of hosts of a specific subnet are not forwarded.
● Incoming and/or outgoing frames of a specific protocol are not forwarded.
Note
Processing order of the lists
The access control lists are processed on the interface in the order in which they were
created.
The index number of the access control list is not used for this.
You are in the ACL standard configuration mode.
The command prompt is as follows:
cli(config-std-nacl)#
To Next Page
Loading...
Need help?
General