Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
577
You enable the ping function for virtual IPv4 addresses with the vrrp virtual-ping
command.
You display the status and the configuration of the VRRP3 interfaces with the
show vrrp3
interface - vrid
command.
Commands in the Interface Configuration mode
This section describes commands that you can call up in the Interface configuration mode.
Note
The commands are only available with layer 3 and only in conjunction with VLAN interfaces.
Router ports are not supported.
In the VRRP3 Router configuration mode, enter the interface command to change to this
mode.
Commands relating to other topics that can be called in the VRRP3 Router configuration
mode can be found in the relevant sections.
● If you exit the VRRP3 Router configuration mode with the
exit command, you return to
the Interface configuration mode.
● If you exit the VRRP3 Router configuration mode with the
end command, you return to the
Privileged EXEC mode.
vrrp accept-mode
Description
With this command, you enable the ping function for virtual IPv6 addresses on the VRRP3
interface.
Note
This command is available only with layer 3.
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
To Next Page
Loading...
Need help?
General