Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
283
Call up the command with the following parameters:
show ipv6 traffic [
interface { vlan <vlan-id> | <interface-type> <interface-id> }
] [hc]
The parameters have the following meaning:
Keyword for the interface via which the statistics
are created.
• VLAN
• Interface
-
Keyword for a VLAN -
Keyword for a VLAN connection
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
Display of the High counters parameter
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the statistics are displayed for all
available IP interfaces.
The statistics are displayed.
You reset the counters to zero with the clear ipv6 traffic command.
show ipv6 static route
Description
This command shows the routes that were generated statically.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General